For example, create motion zones around your driveway or front door to black out unwanted alarms from high traffic nearby roads. But still didn't figure out which file was storing these variables. Client Motion Zone Focus on the Important Areas Specify detection areas and adjust motion sensitivity level for each camera according to your needs. Now it is storing the stream modes correctly. Update 2: I deleted the Reolink folder under AppData (both Local and Roaming) and re-installed the client. I cannot find which file is used to store these settings.had to time to investigate.įor sure thus was caused by the actions I did to try and reproduce the scenario mentioned by Neil. Thus simply shows that it uses the previous settings under AppData which have not been erased. The Freezing issue on Reolink Client Please test whether you will meet the same problem when previewing the camera via Reolink App. Re-installing the same client will not solve the issue.
Reolink client freezes manual#
This is definitely a bug on the way the stream mode setting is stored. Support Center Download Center Software & Manual Contact Us Sign up Log in Sign up Log in. So in every camera I select the stream is ALWAYS FLUENT irrespective of how it was set before. I even changed the stream mode to CLEAR and on the same camera I click on Playback.then I return to the live view of the same camera and the stream mode changed to FLUENT. If the image is frozen when you watch the live-streaming of Reolink cameras via Reolink NVRs monitor, please refer to the below instructions to troubleshoot. I quitted the client and re-run it and the same behaviour was observed. I moved to the other camera and it was FLUENT again.
Reolink client freezes plus#
If yes, please refer to Freezing Issue When Previewing Camera in LAN Note: If your camera is Reolink Go, GO Plus or Go PT, please go to tip 2 directly. I went back to the first camera and the stream mode was FLUENT again. Please check if you will meet the same problem in LAN when your phone/pc is connected to the same network as the camera. Then I changed to clear and clicked on another camera.and it was fluent and I changed it to CLEAR. Update 1: This morning I ran the client and all the streams were FLUENT. Checking in, February 2023 running client version 8.8.4 with 4 cameras (RLC 410WS, RLC-511W, and 2x RLC-511WA). I did follow your sequence but wasn't able to reproduce it.
0 kommentar(er)
